046-0153 Ramp.doc
5/02/04
RESILIENT
MATERIAL
DRIVE PIN
(LOCATION 1)
PLUG (2)
PLUG (3)
DRIVE PIN
(LOCATION 3)
DRIVE PIN
(LOCATION 2)
THRESHOLD
PLATE
ACCESSIBLE
PATHWAY
PLUG
PLUG
(INSTALLED
(INSTALLED
IN RAMP)
IN RAMP)
(INSTALLATION OF RAMP ABOVE PATHWAY SURFACE)
BORDER
DRIVE PIN
LOCATION
RESILIENT
MATERIAL
DRIVE PIN
THRESHOLD PLATE
10 5/8" \[270\]
046-0153
BORDER RAMP W/STAKES, PLATE & PLUGS
5/02/04
RESILIENT
MATERIAL
DRIVE PIN
(LOCATION 1)
OPTIONAL LOCATION
OPTIONAL LOCATION
FOR STONE BORDERS
FOR STONE BORDERS
DRIVE PIN
(LOCATION 3)
DRIVE PIN
(LOCATION 2)
ACCESSIBLE PATHWAY
(INSTALLATION OF RAMP OFF THE END OF A PATHWAY SURFACE)
BORDERS CAN BE LOCATED
AT EITHER POSTION
DRIVE PIN
DRIVE PIN
RESILIENT
MATERIAL
2 5/8
8" \[203\]
046-0153
BORDER RAMP W/STAKES, PLATE & PLUGS
PARTS LIST SPECIFICATIONS
PART NO. DESCRIPTION QTY
STONE BORDER RAMP W/DRIVE PINS, THRESHOLD
PLATE & PLUGS: Ramp: Recycled black, linear low density
046-0153 STONE BORDER RAMP W/DRIVE 1
polyethylene (LLDPE), .25" thick, double wall construction.
PINS, THRESHOLD PLATE & PLUGS
Drive Pins: 3/4" dia. galvanized steel. Threshold Plate: 12 GA
galvanized plate with a PVC coated finish. Plugs: 13/16"
plastic hole plugs.
Note: Hardware package(s) may include extra hardware
that is not necessary for this installation.
SHIPPING WEIGHT: 120 LBS.
INSTALLATION INSTRUCTIONS
NOTE: SEE SITE PLAN FOR SPECIFIC LAYOUT OF STONE BORDER RAMP.
For installation of ramp above pathway surface (See Installation A):
1. Position ramp in location as shown on the site plan.
2. Align holes in both border and ramp.
3. Drive a 30” drive pin through holes in both border and ramp and into the ground until the head of the drive pin is tight against the
top of the ramp. See LOCATION 1.
NOTE: Positioning ramp on existing concrete pathway may require drilling holes through concrete prior to drive pin
4.
installation.
5. On opposite end of ramp, drive 30” drive pins through holes in threshold plate and ramp into the ground until the head of the
drive pin is tight against the top of the plate. See LOCATION 2 and 3.
NOTE: Positioning ramp on existing concrete pathway may require drilling holes through concrete prior to drive pin
6.
installation.
7. Install plugs into open holes on ends of ramp. (Two plugs on one side, three plugs on opposite side)
For installation of ramp off the end of a pathway surface (See installation B):
1. Position ramp in location as shown on the site plan.
2. Determine location of stone borders.
3. Align holes in both border and ramp.
4. Drive a 30” drive pin through holes in both border and ramp and into the ground until the head of the drive pin is tight against the
top of the border. See LOCATION 1.
5. On opposite end of ramp, drive 30” drive pin through holes in both border and ramp and into the ground until the head of the
drive pin is tight against the top of the border or ramp. See LOCATION 2 and 3.
046-0153.doc REV: 01 PCN: 04-0051 5/02/2004