20070409133451.pdfDATE: April 9, 2007
City of Edmonds
PLAN REVIEW COMMENTS
BUILDING DIVISION
(425) 771-0220
TO: Robert Satko
Local Plumbing and Construction
FAX: 425-413-8467
FROM: Ann Bullis, Assistant Building Official
RE: Pian Check #2007-0343
Project: Endodontics NW — Plumbing and Medical Gas
Project Address: 2191176"' Ave W, #208
During review of the plans for the above noted project, it was found that the following information,
clarifications or changes are needed. Provide written responses to each comment and where changes can be
found on the plans. Submit revised plans/documents to Marie Harrison, Permit Coordinator.
1. Provide plumbing plans for the water lines, drain, waste and venting (see enclosed handout for minimum
submittal requirements).
2. Provide manufacturer's information for dental compressor and vacuum system.
H&V
city of edmonds
development information
Plumbing
Permit Submittal Requirements
.PERMIT REQUIRED: A permit is required to install, alter, repair, relocate, or replace any
portion of a potable or waste plumbing system. Including gas hot water
tank replacement, water service line repair or replacement, propane
tanks, and to install or alter gas piping.
EXEMPT WORK: The clearing of stoppages or the repairing of leaks in drains, pipes,
valves, vents or fixtures, and the removal and reinstallation of water
closets, provided such repairs do not involve or require the replacement
or rearrangement of valves, pipes or fixtures.
CODES: Uniform Plumbing Code (Current Edition)
International Fuel Gas Code (Current Edition)
LPG per 2001 NFPA-58 and 2002 ANSI 2223. 1 /NFPA-54
FEE: Base fee $30 plus additional fees based on the number and type of
plumbing fixtures plus $15 City surcharge fee
SUBMITTAL REQUIREMENTS FOR NEW INSTALLATIONS:
1. Plumbing Fixture Schedule Form (See Handout #B, attached)
2. On a scaled floor plan show the following:
a. Drain, Waste and Vent piping layout; sizing, slope and pipe material
b. Potable water line layout, sizing and pipe material
c. Fixture unit and flow calculations to support line sizing
3. Cross connection devices are required on all direct connections to the potable water system.
Specify all fixtures that require cross connection devices (i.e., ice machines, soap ejection
systems, beverage dispensers, boilers, etc.) and note the make and model of each device.
4. Indicate the location and cross connection device for premise isolation
5. Manufacturer's specifications for equipment such as sump pumps, ejector pumps, water heater
boosters, etc_
6. Gas piping layout, sizing and pipe material, pipe sizing calculations, maximum design operating
pressure and location of pressure regulators
7. For Commercial and Multifamily projects, provide Listed and Tested Fire Stopping Assemblies
NOTE: THE PURPOSE OF THIS HANDOUT IS TO ASSIST THE PUBLIC IN COMPLYING WITH DETAILED PERMIT SUBMITTAL
REQUIREMENTS_ IT IS NOT A COMPLETE LIST OF PERMIT OR CODE REQUIREMENTS AND SHOULD NOT BE USED AS A SUBSTITUTE
FOR APPLICABLE LAWS AND REGULATIONS. IT IS THE RESPONSIBILITY OF THE OWNERIDESIGN PROFESSIONAL TO REVIEW THE
SUBMITTAL FOR COMPLETENESS AND APPLICABILITY TO OTHER CODES. ONLY COMPLETE APPLICATIONS WILL -BE ACCEPTED
BY THE CITY FOR REVIEW
L:ITEMPIBUILDINGIHANDOUT ICODES/PLUMBING B55 8146