20080123080034.pdfTO: Jan Conner
nwcinns@hotmail.com
FROM: Jenny Readwin, Plans Exine
RE: Plan Check # 2008-0020
Project: Harbor Inn Signs
Project Address: 130 W. Dayton Street
During review of the above noted application, it was found that the following information,
corrections, or clarifications are needed. Please redline plans or submit two (2) sets of revised
plans/documents (affected sheets only) with a written response to each of the items below to a
Permit Coordinator.
1) Please clarify on the pole sign the proposed scope of work (i.e. new sign on existing poles, etc.).
2) Clearly show entire pole sign including height. If replacing sign on existing poles provide copies
with dimensions of existing sign. If the square footage of the proposed sign is greater than the
square footage of the existing sign then wind load calculations stamped and signed by a
Washington State Licensed Professional Engineer are required. If the proposed sign is all new
(pole, footings, etc.) then please provide complete plans and construction details including
stamped and signed wind load calculations.
3) Provide connection detail for proposed pole sign whether attached to existing or proposed poles.
City of Edmonds
PLAN REVIEW COMMENTS
BUILDING DIVISION
�St 1 g90
(425) 771-0220
DATE: January
23, 2008
TO: Jan Conner
nwcinns@hotmail.com
FROM: Jenny Readwin, Plans Exine
RE: Plan Check # 2008-0020
Project: Harbor Inn Signs
Project Address: 130 W. Dayton Street
During review of the above noted application, it was found that the following information,
corrections, or clarifications are needed. Please redline plans or submit two (2) sets of revised
plans/documents (affected sheets only) with a written response to each of the items below to a
Permit Coordinator.
1) Please clarify on the pole sign the proposed scope of work (i.e. new sign on existing poles, etc.).
2) Clearly show entire pole sign including height. If replacing sign on existing poles provide copies
with dimensions of existing sign. If the square footage of the proposed sign is greater than the
square footage of the existing sign then wind load calculations stamped and signed by a
Washington State Licensed Professional Engineer are required. If the proposed sign is all new
(pole, footings, etc.) then please provide complete plans and construction details including
stamped and signed wind load calculations.
3) Provide connection detail for proposed pole sign whether attached to existing or proposed poles.