2009-0388 Artistic Wall #2.pdf
City of Edmonds
PLAN REVIEW COMMENTS
BUILDING DIVISION
(425) 771-0220
DATE: September 11, 2009
TO: Ronald D. Johnson, Architect
Ronmaile@verizon.net
FROM: Leif Bjorback, Assistant Building Official
RE: Plan Check: 2009-0388
Project: Artistic Wall TI review #2
th
Project Address: 610 5 Ave S. Suite G
During review of the plans for the above noted project, it was found that the following information,
clarifications or changes are needed. Please provide written responses as to where the changes can
be found on the plans, and submit revised plans/documents to Theresa Umbaugh, Senior Permit
Coordinator. Thank you.
1.Please indicate on the floor plan the location of the new sinks.
2.Please provide manufacturerÂ’s specifications on the sump and pumps. These must be listed
by an approved agency. UPC 301.1.1
3.The sump must contain dual pumps, and have audio and visual alarms. Please verify this in
the manufacturer specifications and note this on the plans. UPC 710.9
4.Indicate on the drawing that the discharge lines connect to the gravity drain from the top
through a wye branch fitting. UPC 710.4
5.Indicate a ball or check valve on the discharge lines. UPC 710.4
6.Please provide manufacturerÂ’s specifications on the clay catcher (I assume this is a solids
interceptor?) This device must be listed by an approved agency. UPC 301.1.1 and 1009
7.At the 3 compartment sink, one trap may serve the set of sinks if the waste outlets are not
more than 30 inches apart and the trap is centrally located. Please alter the plans accordingly.
If this will be the location of the solids interceptor, note this on the drawing. UPC 1001.2