2013-0922 Winterer patio cover.pdf
City of Edmonds
PLAN REVIEW COMMENTS
BUILDING DIVISION
(425) 771-0220
DATE: September 10, 2013
TO: Jeff Raemer
jeffraemer@gmail.com
FROM: Chuck Miller, Plans Examiner
RE: Plan Check: BLD2013-0922
Project: Winterer patio cover
th
Project Address: 9230 215 Street SW
During a review of the plans for the above noted project, it was found that the following
information, clarifications, or changes are needed. Please provide written responses as to where the
changes can be found on the plans, cloud all changes on the revised plans, and submit the revised
plans/documents to a Permit Coordinator. Thank you.
1.Indicate on the plans the required fasteners (diameter and length, screw or bolt) and on-
center spacing used to attach the ledger to the structure.
2.Indicate on the plans the building element that the patio cover ledger is being attached to. It
must be capable of supporting the additional load of the patio cover (not fascia or the ends of
roof rafters).
3.Provide specifications on the ‘corrugated roof’ material to be used as a roof covering and the
means of attachment required to resist the component and cladding loads (wind/uplift)
specified in Table R301.2(2).
4.Clarify the callout for 1x6 cedar to be used as roof rafters. The 1x material does not meet
the structural requirements of R802.5 or the American Forest & Plywood Association
(AF&PA) for use as rafters.
5.Clearly indicate on the plans the locations of the 4x8 cedar beams, their bearing points, and
required footings to support the loads. One of the beams is identified, and a few others
appear to be represented, but all appear to be over spanned.
6.Indicate on the plans the portion of the existing patio cover that is to be repaired and/or
retained for use.