2017-1580 ABC Learning plumbing.pdfCity of Edmonds
OV EDAI 0
PLAN REVIEW COMMENTS
. ..... BUILDING DIVISION
(425) 771-0220
DATE: November 15'h 2017
TO: Minnis Custom Plumbing
TRMINNIS@HOTMAIL.COM
FROM: Eric Carter, Plans Examiner
RE: Plan Check: BLD2017-1580
Project Address: 23632 Highway 99 Suites 1500, 1600, and 1700
Scope: Plumbing system installation for ABC Learning Center
Please be advised that the building plans for the above referenced project have been disapproved
for the purposes of obtaining a building permit. During a review of the plans by the Building
Division for compliance with the applicable building codes, it was found that the following
information, clarifications, or changes are needed. Reviews by other divisions, such as Planning,
Engineering, or Fire, may result in additional comments that require attention beyond the scope of
this letter. Items that recur on this list appear in italics.
A complete review cannot be performed until the revised plans/documents, including a
written response in itemized letter format indicatinz where the 'clouded' or otherwise
highlij!hted chani!es can be found on the revised plans, have been submitted to a Permit
Coordinator.
Resubmittals must be made at the Development Services Department on the 2 nd Floor of City Hall.
Permit Center hours are M, T, Th, & F from 8am-4:30pm and from 8:30am-12pm on Wednesdays.
This building plan review cannot be completed until we receive the following items:
General:
1. It appears that hot water supply lines that feed the proposed laundry room (107) and
restroorn (110) exceed the allowable limits from the heat source as required in
sections C404.3, C404.3. 1, and C404.3.2 of the 2015 Washington State Energy
Code. Please provide plans that comply with the fore mentioned sections, for your
convenience I have included table C403.3.1 for reference.
TABLE C404.3.1
PIPING VOLUME AND MAXIMUM PIPING LENGTHS
NOMINAL PIPE SIZE
(inches)
VOLUME
(liquid ounces per foot length)
MAXIMUM PIPING LENGTH
(feet)
Public lavatory faucets
Other fixtures and appliances
1/4
0.33
6
50
5/16
0.5
4
50
3/8
0.75
3
50
1/2
1.5
2
43
5/8
2
1
32
3/4
3
0.5
21
7/8
4
0.5
16
1
5
0.5
13
11/4
8
0.5
8
11/2
11
0.5
6
2 orlarger
18
0.5
4
Please let me know if I can be of any additional assistance.
Eric Carter
Page 2 of 3
Page 3 of 3