20180525071331.pdfMay 07, 2018
Attn: Chuck Miller
City of Edmonds Building Division
1215 th Ave N i
Edmonds, WA 98020 architecture - design
I received the correction notice for project tMLD20171743' ated April 20, 2018. Below are the
requested corrections and locations on the drawings where they can be found:
1. Project Valuation to be revised to 49,966. Refer to attached itemized estimate from the
General Contractor.
2, See attached approval letter from Environmental Health Division of the Snohomish Health
District based on the plans dated 3/20/18.
3. General Notes
a. 1. Codes
i. Note revised to "IBC". Refer to 01 Sheet.
ii. "Residential" eliminated from notes. Refer to 01 Sheet.
b. 6. Energy
i. First note code reference revised to "IBC". Refer to 01 sheet.
ii. Third note eliminated. Refer to 01 sheet.
c. 7. Exit Signs — First note code reference revised to "1013". Refer to 01 sheet.
d. 8. Stairs
i. First note code reference revised to "1011.3". Refer to 01 sheet.
ii. Second note code reference revised to "1014". Refer to 01 sheet.
iii. Third note code reference revised to "1014". Refer to 01 sheet.
e. 9. Insulation
i. First note code reference revised to applicable sections found in the WSEC
Commercial Provisions. Refer to 01 sheet.
ii. Second note eliminated. Refer to 01 sheet.
iii. Fourth note revised to include information found in WSEC Table C402.1.3.
Refer to 01 sheet.
4. Note added indicating required directional signage at inaccessible ramp to nearest accessible
route. Refer to 02 sheet.
S. Main Floor Plan
a. Guardrail Height revised to 42" at stairs/landing to door'03'. Refer to sheet Al.l.
b. Private Lounge door proposed to be removed to provide 32" clear framed opening.
Refer to sheet Al. I.
c. Safety glazing not required at existing window. Window is clear of the 24" arc per
IBC2406.2 Refer to sheet Al. 1. Window does not meet the 18" bottom glazing
height requirement #2 of IBC 2406.4.3. Existing bottom glazing dimension is 3,-1
3/8". Refer to sheet A2.0.
d . Safety glazing not required at existing window. Window does not meet the 18"
bottom glazing height requirement #2 of IBC 2406.4.3. Existing bottom glazing
dimension is Y-1 3/8". Refer to sheet A2.0.
e. Note added indicating required directional signage at inaccessible ramp to nearest
accessible route. Refer to sheet Al.l.
f. Note revised to provide 'outdoor air' at the Private Lounge, Lounge A,B, and C.
Refer to sheet Al. 1.
6. Door Schedule
a. IBC 1010.1.10 specific guidelines added to the Door Schedule Notes. Refer to sheet
Al.l.
b. Door #4 revised to a 36" leaf door. Refer to sheet Al.l.
RESUB
23020 Edmonds Wag, -113, EdmorxJs, WA 98020 1 p. 206,542.3734 1 e. hekMh2dorchftects.com I w h2darchftects.com MAY 2 4 2018
. -W 5 -
.. WFFMOt9q&�N'
7. Electric tankless water heater — mark'35' - location revised to be below lavatory. Refer to
sheet Al. 2.
8. South Elevation
a. Safety glazing not required at existing window. Window is clear of the 24" arc per
IBC2406.2 Refer to sheet Al.l. Window does not meet the 18" bottom glazing
height requirement #2 of IBC 2406.4.3. Existing bottom glazing dimension is 3'-1
3/8", Refer to sheet A2.0.
b. Safety glazing not required at existing window. Window does not meet the 18"
bottom glazing height requirement #2 of IBC 2406.4.3. Existing bottom glazing
dimension is 3'-1 3/8". Refer to sheet A2.0.
c. Guard limit openings note revised to 'limit the passage of a 4" sphere' per IBC
101S.4. Refer to sheet A2.0.
d. Grade at deck proposed to lower 5" to accommodate framing dimension. Refer to
site plan on 01 sheet and sheet A2.0.
9. Partial East Elevation
a. Guard limit openings note revised to 'limit the passage of a 4" sphere' per IBC
1015.4. Refer to sheet A2.0.
b. Grade at deck proposed to lower 5" to accommodate framing dimension. Refer to
site plan on 01 sheet and sheet A2.0.
10. Partial West Elevation -Guard limit openings note revised to 'limit the passage of a 4"
sphere' per IBC 1015.4. Refer to sheet A2.0.
11. Grade at deck proposed to lower 5" to accommodate framing dimension. Refer to site plan
on 01 sheet and sheet A2.0. No change to structural sheets.
12. Main Floor Electrical Plan
a. Occupancy sensor controls requirements noted in the following spaces: Lounge A,
B, and C, Private Lounge, Office Storage, and Wine Storage. Refer to sheet E1.0.
b. Time switch controls with manual override requirements noted at the following
spaces: Hall, Bar, and Kitchen. Refer to sheet E1.0.
13. Interior Lighting - Permanent current limiting feeds proposed at Kitchen and Bar tracks to
meet energy compliance. Refer to attached LTG-INT-SPACE checklist.
I can be reached at 206-542-3734 or at heidiCc)h2darchitects.corn with any further questions.
Regards,
Heidi Helgeson
Principal
H2D Architecture + Design
23020 Edmonds WaW, *113, Edmonds, WA 98020 1 p. 206.542.37341 e. heid0h2clarchftects.com I w. h2darchftects.corn