bld20080651-Zubair-1.doc
City of Edmonds
TH
121 5 AVENUE NORTH • EDMONDS, WA 98020 • (425) 771-0220 FAX(425) 771-0221
Website: www.ci.edmonds.wa.us
PUBLIC WORKS DEPARTMENT
Engineering Division
Plan Review Corrections
Plan Check : Date:
# 2008-0651 February 12, 2009
th
Project Name/Address:
Zubair 22415 100 Ave W Remodel
Contact Person/Address/Fax:
Aneil Zubair aneilzubair@gmail.com
Reviewer: JoAnne ZulaufDivision:Engineering
During review of the subject submittal, it was found that the following information, corrections, or
clarifications would need to be addressed. All Handouts referred to in these comments can be accessed at
our website: www.ci.edmonds.wa.us under City Government / Development Services Department /
Engineering Division then scroll down to Handouts:
Original Site plan showed driveway etc as existing therefore at the time I had no comments. Please see the
following in response to your most recent site plan submittal:
1.The impervious surface calculations need to be added to the site plan and separated as follows; “Pre-1977
Existing”, “Post-1977 Existing” and “Proposed”. Please note year constructed next to the “Existing”
amounts. Please include all new paver areas.
If the total post-1977 impervious surface is 2000 square feet or more,
a.per Edmonds
Community Development Code Section 18.30.060, any new development or redevelopment with
more than 2,000 square feet of new impervious surfacing shall be required to provide storm water
quality control. Please provide a drainage plan with a detention system. See City of Edmonds
Handout #E72 available on our website for guidance with requirements and sizing.
If the total post-1977 impervious surface is under 2000 square feet
b., please note on site plan if
intending to tie addition into existing system or use some other means to handle the drainage for
the proposed addition.
2.Please add note on site plan stating that Erosion control will be in place as needed per City of Edmonds
Standard Details.
3.Per City of Edmonds Community Development Code, driveways are not permitted over 14% slope. A
written request to the City Engineer can be submitted for a slope waiver up to 20%. Please submit a
letter to the City Engineer requesting a slope waiver. Include in detail why maximum slope can not be
met.
DATE FAXED/E-MAILED 7/3/2017 PAGE __1__ OF __1_
Please resubmit 3 copies of the revised plans/documents to a Development Services Coordinator. Please
contact me at 425-771-0220 if you have specific questions regarding these plan corrections.
DATE FAXED/E-MAILED 7/3/2017 PAGE __1__ OF __1_