bld20140473-Salish_Arch-E1.pdf
CITY OF EDMONDS
PLAN REVIEW COMMENTS
ENGINEERING DIVISION
(425) 771-0220
City Website: www.edmondswa.gov
DATE:May 27, 2014
TO:Homero Nishiwaki
hnishiwaki@j-arch.com
FROM:Jeanie McConnell, Engineering Program Manager
RE:Application#:bld20140473
Project:Salish Crossing –Brick Archway & Wooden Trellis
Project Address: 190 Sunset Ave S
During review of the above noted application, it was found that the following information,
corrections, or clarifications are needed. Please redline plans or submit three (3) sets of revised
plans/documents with a written response to each of the items below to a permit coordinator.
City of Edmonds handouts,standard detailsand development codecan be referenced on the City
website.
1)Please clarify location of stamped concrete area vs. pavers. Are either surfaces intended to be a permeable
surface? If so, please provide details for construction.
Please provide the impervious surface calculations in the table format provided below.
2)
IMPERVIOUS SURFACE CHART
LineTypeArea (square feet)
1.Non-Regulated
ExemptRegulated
2.Replaced
3.New (Post 1977) +
Total Regulated Impervious Area
=
4.
Mitigation required if in excess of 2000sf
5.Total Area Mitigated by Existing Stormwater Management System(s)-
=
6.Regulated Area Not Yet Mitigated
=
7.Area Proposed to be Mitigated by Low Impact Development Techniques
=
8.Area Proposed to be Mitigated through Conventional SWM Techniques
bld20140473-Salish_Arch-E1.docx Page 1of 2
3)Add note that states proposed stampedconcrete surface shall be located entirely on private
property and shall match flush into theexisting sidewalk.
4)Show location of existing utilities on the site, including water, sewer and storm.
5)Confirm footings for arch will be located entirely on private property.
Please contact me at 425-771-0220 or by e-mail at jeanie.mcconnell@edmondswa.govif you have
specific questions regarding these plan corrections.
Page 2of 2