Loading...
Inspection Correction Notice 10.23.19.doc DATE: October 23,2019 PERMIT NUMBER: BLD20180811, ENG20190006 OWNER: Hann Homes LLC SITE CONTACT: Mark Hann ADDRESS: 20818 72nd Ave W TYPE OF INSPECTION: Curb/Gutter Pre-Pour WORK DESCRIBED BELOW HAS BEEN INSPECTED AND APPROVED APPROVED PLANS AND PERMIT JOB CARD MUST BE AVAILABLE TO INSPECTOR ON SITE CORRECTIONS LISTED BELOW MUST BE MADE BEFORE WORK CAN BE APPROVED AND/OR THE NEXT PHASE OF WORK IS STARTED. RECALL FOR INSPECTION REINSPECTION FEE MUST BE PAID PRIOR TO NEXT INSPECTION REQUEST. STOP WORK UNTIL AUTHORIZED TO CONTINUE BY CITY INSPECTOR Cut asphalt back 2’ in front of all new/replaced curb and gutter, consistent with City standard detail TR-520. Make a straight cut on the broken piece of asphalt at the approach to the neighbor’s driveway, at the North ADA ramp. Due to broken corner of concrete in high capacity gutter, a section of the high capacity gutter shall also be removed and replaced. Neat line sawcut at north edge of repair shall align with the sawcut in the asphalt. Refer to City standard detail TR-544 for high capacity swale requirements. Remove and replace all existing broken sections of curb and gutter as identified in the field. Re-install high capacity gutter at south end of the project. Refer to TR-544 as needed. Lower driveway entrance lip from 1” to ½”. Concrete curb ramps shall have no lip. Add lights to barricades at both ends of the project for nighttime closure of sidewalk. Recall for inspection of forms prior to pour. For inspection scheduling call 425-771-0220 x1326. 1 Page 2 of 2 CITY OF EDMONDS CORRECTION NOTICE ENGINEERING DIVISION (425) 771-0220 City Website: www.edmondswa.gov