BLD2021-0889+Supplementals+6.25.2021_8.54.17_AM+2269281i
Jurisdiction: Edmonds
Project Name: Catlin dining room addition
Application ID: 982912
Supplemental Name: Residential Addition Project Information
New (added) Square Footage:
1st Floor
143
New (added) Square Footage:
2nd Floor
0
New (added) Square Footage:
3rd Floor
0
New (added) Square Footage:
Deck(s)
0
New (added) Square Footage:
Garage(s)
0
New (added) Square Footage:
Storage
0
Number of NEW bedrooms:
0
Number of NEW bathrooms:
0
Total square footage of new or replaced impervious surface:
MYSuiIdinaPermit.com
(common impervious surfaces include, but are not limited to, roof tops, walkways, patios, driveways, parking lots or storage areas, concrete or
asphalt paving, gravel roads, packed earthen materials, and oiled, macadam or other surfaces that similarly impede the natural infiltration of
stormwater).
143
Total new lot coverage percentage with the addition:
(Structural lot coverage includes the total ground coverage of all buildings or structures on a site measured from the outside of external walls
or supporting members or from a point 2.5 feet in from the outside edge of a cantilevered roof, whichever covers the greatest area).
36.81
Be sure you submit the following to ensure your application is accepted and not delay your project:
1) WA STATE ENERGY CODE: Show R values of insulation and U values of glazing. Show energy credits proposed to meet energy
code requirements.
2) STRUCTURAL CALCULATIONS: Plans which do not meet conventional construction must be designed in accordance with the
structural provisions of the International Building Code by a Washington Sate licensed Design Professional with supporting
calculations.
Supplemental Name: Plumbing Fixtures - Residential Building Permits
Enter the number of plumbing fixtures being installed, altered, repaired, added or relocated:
Water Heater(s). ENTER QTY and specify GAS or ELECTRIC
r,
4 � L
i
Jurisdiction: Edmonds
Project Name: Catlin dining room addition
Application ID: 982912
f
MyBui ldi ngPermi t. cem
0
Plumbing fixture(s) on one trap or set of fixtures on one trap - Includes sinks, toilets, tubs, showers, etc. ENTER QTY
0
Drain(s) w/in footprint of building (rainwater systems, roof deck drains, etc.) ENTER QTY
0
Re -pipe. Drain(s), vent(s) or water piping for each fixture served. ENTER QTY
0
Water service line(s) - replacement or repair only. ENTER QTY
0
Water service line(s) - New only. ENTER QTY
0
Water treating equipment (water softener). ENTER QTY
0
Backflow protective device(s) - 2" and smaller. ENTER QTY
0
Backflow protective device(s) - Over 2". ENTER QTY
0
Graywater system(s) or reclaimed water system(s) in addition to fixtures. ENTER QTY
0
Non -grease waste pre-treatment interceptor(s) - Oil/water separator. ENTER QTY
0
Medical gas piping system(s). ENTER QTY
0
Grease trap(s) - HGI inside building. ENTER QTY
0
Gravity grease interceptor(s) - GGL ENTER QTY
0
Supplemental Name: Mechanical Equipment - Residential Building Permits
Enter the number of mechanical equipment units being installed or relocated:
Furnace(s) - Forced -air or gravity -type, includes ducts and appliance vents. ENTER QTY
0
Air handler(s) - Includes ducts (Diffusers, blowers, etc.)
- Up to and including 10,000 cfm (4719 L/s). ENTER QTY
0
Air handler(s) - Includes ducts (Diffusers, blowers, etc.)
- Over 10,000 cfm (4719 L/s). ENTER QTY
0
r,
4 � L
i
Jurisdiction: Edmonds
Project Name: Catlin dining room addition
Application ID: 982912
Gas Heater(s) - Suspended, recessed wall or floor -mounted units. ENTER QTY
13
Hydronic Heating System(s). Enter QTY
7
Appliance Vent(s) - Type B, BW, L gas vent, etc. ENTER QTY
13
Incinerator(s). ENTER QTY
f
MyBui ldi ngPermi t. cem
Ventilation and Exhaust - Fan(s) connected to single duct (bath, laundry, kitchen exhaust) or each system which is not a portion of any
heating or air-conditioning system. ENTER QTY
311
Hood(s) - Type 1, Type 2 or Fume Hood including ducts. ENTER QTY AND TYPE
13
Gas Piping - New or relocated. ENTER QTY
rel
Boiler(s) or Compressors(s) -
Up to and including 50 HP (176 KW). ENTER QTY
it
Boiler(s) or Compressors(s) -
Over 50 HP (176 KW). ENTER QTY
Absorption System(s), Air Conditioning System(s) or Heat Pump(s) -
Up to and including 1,750,000 Btu/h (512.9 kW). ENTER QTY
M
Absorption System(s), Air Conditioning System(s) or Heat Pump(s) -
Over 1,750,000 Btu/h (512.9 kW). ENTER QTY
M
Roof Mounted HVAC Units are:
Not applicable
Each appliance or piece of equipment regulated by the IMC for which no other item is listed (Fire dampers, ductless mini -split
systems, etc.) ENTER QTY and EQUIPMENT ITEM
Extend existing heating duct into new addition
Supplemental Name: Authorization and Acknowledgment - Building
All provisions of laws and ordinances governing this type of work will be complied with. I certify under penalty of perjury that the
information provided on this application is true and correct and, further that I am authorized by the owner of the above premises
to perform the work for which the permit application is made. I further agree to hold harmless the City of Edmonds as to any
claim (including costs, expenses, and attorney's fees incurred in investigation and defense of such claim), which may be made by
any person, including the undersigned, and filed against the City of Edmonds, but only where such claim arises out of the reliance
of the City, including its officers and employees, upon the accuracy of the information supplied to the City as part of this
application.
I hereby authorize the City representatives to inspect my property Monday -Friday between the hours of 8:00 a.m. and 5:00 p.m.
F t tt.
MyBuildingPermitxom
[P �; rcliXcov. ne!
Jurisdiction: Edmonds
Project Name: Catlin dining room addition
Application ID: 982912
during this permit application process for verifying site conditions.
I certify, under the penalty of perjury under the laws of the State of Washington, that the information and exhibits herewith
submitted are true and correct to the best of my knowledge and that I am authorized to file this application on behalf of the
owner of the subject property.
Yes
The City of Edmonds makes permit applications available to the public in an effort to make its processes as transparent as
possible. By signing or initialing this document, I acknowledge that any and all information submitted as part of this application, is
public information. I further acknowledge and agree that this permit application, and any and all documents related
thereto, may be disclosed by the City of Edmonds to the public without redaction.
Enter your digital signature below.
Jack Fingold
Electronic documents submitted to the City of Edmonds for plan review and permit issuance must be provided in a format that does
not prevent the City from making code comments on the documents during review or from making the documents ready for permit
issuance. Documents submitted in any manner that prevents the City from completing the review and permit issuance process,
including but not limited to submitting documents that are locked, may result in additional review time, permitting delays, and/or
cancellation of the permit application if the problem is not resolved by the applicant in a timely manner.
Please refer to chapter 18.43 RCW, chapter 18.210 RCW, chapter 196-23 WAC and chapter 196-33 WAC for Washington State laws
governing electronic documents. An interpretative guideline from the Board of Registration for Professional Engineers and Land
Surveyors can be found at Ltp://www.dol.wa.gov/business/engineersiandsurveyors/docs/eDocsinterpretiveGuideline.pd]. These laws
and requirements are subject to change and the submitting parties are responsible for keeping apprised of any such changes.
Please acknowledge that you understand these requirements and have verified the electronic documents being submitted meet the
City of Edmonds submittal requirements by selecting the dropdown below. If you have questions, contact permit processing
at onlinepermits@edmondswa.gov or 425-771-0220.
Yes, I acknowledge