FIR2023-0044+Email from Fire+5.3.2023_10.25.59_AM+3521720Lennie Mueller
From: Burt, Chris <cburt@southsnofire.org>
Sent: Thursday, April 20, 2023 3:20 PM
To: Trent Lynn
Cc: Mereness, Daina
Subject: RE: South Sno Fire: Permit procedure guidance - Notification Power Supply Panel
Replace - 51 Pine St, 98020
Attachments: SCF STANDARD - Fire Alarm and Detection - 2021.pdf
Hello Trent,
If they are failing and need to be replaced in order to keep the fire alarm system operational you can change them prior
to obtaining a permit. You will need to submit for an "Over the Counter" permit as soon as possible. Please include cut
sheets of the power supplies being installed. Apply for the permit on: onlinepermits@edmondswa.gov. After the permit
is issued please request an inspection. I have attached the South County Fire Alarm Standard. Please call me with
questions.
Thank you
Chris Burt
Deputy Fire Marshal
12425 Meridian Ave. S, Everett WA 98208
Fire Prevention: (425) 551-1264 1 0: (425) 327-5800
cburt@southsnofire.org I www.southsnofire.org
The information contained in this transmission may contain privileged and confidential information, including protected health information covered by
federal and state privacy laws. It is intended only for the use of the person(s) named above. If you are not the intended recipient, you are hereby notified
that any review, dissemination, distribution, or duplication of this communication is strictly prohibited. If you are not the intended recipient, please
contact the sender by reply email and destroy all copies of the original message.
From: Trent Lynn <tivnn@smithfire.com>
Sent: Thursday, April 20, 2023 2:40 PM
To: Prevention <prevention@southsnofire.org>
Subject: South Sno Fire: Permit procedure guidance - Notification Power Supply Panel Replace - S1 Pine St, 98020
Some people who received this message don't often get email from tlynn@smithfire.com. Learn why this is important
Good afternoon,
I am just following up on my voicemail regarding this project.
Our customer, Point Edwards Condominiums, has two (2) notification power supplies that are failing
(deficiency) and in need of replacement. We would like to get the panels replaced and load calculations
completed in the same effort.
Will Smith Fire Systems be able to make the repairs, then submit the load calculations prior to permit
submittal? Or, is there an over-the-counter permit that would be available for this situation? Please advise.
Thank you,
Trent Lynn, SET I Fire Alarm Estimator
Smith Fire Systems
1106 54th Ave East I Tacoma, WA. 98424
T 253 248 2014 1 F 253 926 2350
Email: tlynn(cDsmithfire.com
Web: http://www.smithfire.com/
NICET #119584
Water -Based Systems Layout, Level II
Special Hazards Systems, Level III
Fire Alarm Systems, Level III