BLD2024-1444_Supplementals_PV_Residential_Solar_Checklist_11.1.2024_1.00.49_PM_4597250MyBui ldingPermi t. com
Jurisdiction: Edmonds
Project Name: Ladonna Wolbert - Solar
Application ID: 1572569
Supplemental Name: PV Residential Solar Checklist
Is the PV System designed and proposed for a detached single-family house?
Yes
Is the PV System designed for rooftop of a house in general compliance with applicable codes?
Yes
Is the mounting system engineered and designed for PV?
Yes
Is the rooftop made from lightweight material such as shingles?
Yes
Has the PV system been permitted and pre -approved by the Labor and Industries Electrical Division?
Yes
To address uplift, are the panels mounted no higher than 18" above the surface of the roofing to which they are affixed? Except for flat roofs,
no portion of the system may exceed the highest point of the roof.
Yes
Do the total dead load of panels, supports, mountings, raceways and all other appurtenances weigh no more than one of the
following?
If YES; indicate which.
If NO; select "Does not meet total dead load requirements".
The total is no more than 3.5 pounds per square foot.
Supports for solar panels are installed to spread the dead load across as many roof -framing members as needed to ensure that no
point loads in excess of 50 pounds are created.
Yes
Attachment to the roof is specified by the mounting system manufacturer.
Yes
One of the following fire safety features will be implemented. If YES, indicate which:
At least one 3 foot path is provided from roof gutter to ridge for firefighter access.
Home is code compliant to setbacks and height, or code allows expansion of nonconformity for solar panels.
Yes
Panels are mounted no higher than the roof ridge or apex of roof (applies only to pitched roofs).
Yes
What is the total kilowatt generation of the pv system?
6.560
By checking the box below, I certify that all of the information provided on this form is correct.
I certify
I acknowledge this solar energy installation does not the exceed the 25' height limit. A Conditional Use permit is required for any Solar
installations over the height limit (36" max). Installations made over the height limit without a Conditional Use permit may be subject
to code enforcement and removal.
Installation over the height limit (up to 36') may be approved as a Type If staff decision if it is designed and located in such a way as to
provide reasonable solar access while limiting visual impacts on surrounding properties. Please refer to ECDC 21.40.030(D)(7) and
contact our Planning Department at planning(cDedmondswa.gov with any questions.
i-k 4-ON4,Ftp,b
Jurisdiction: Edmonds
Project Name: Ladonna Wolbert - Solar
Application ID: 1572569
Type your name below that you acknowledge:
Stephanie Hawkins
MyBuildingPermit.com